Data Transfer Rate Converter

Data transfer rate conversion between bits-per-second (bps) and bytes-per-second (B/s) families. Essential for comparing internet connection speeds, file transfer estimates, storage throughput, and network capacity planning.

All conversions in this category are computed relative to a single base unit (Bit per Second) using factors sourced from NIST Special Publication 811 and the BIPM SI Brochure. A shared reference unit keeps the conversion relationships consistent. Converting directly from the original measurement avoids the rounding differences that can accumulate when displayed intermediate results are entered again.

This calculator supports 10 units, including Bit per Second, Kilobit per Second, Megabit per Second, Gigabit per Second, Terabit per Second. Choose the unit shown in your source measurement, then the unit needed for your result.

Units may have alternate spellings or abbreviations. You can search using these names too. Examples include Bit per Second (bps, also written as bit/s or bits per second), or Kilobit per Second (Kbps, also written as kbps or kbit/s), or Megabit per Second (Mbps, also written as mbps or mbit/s).

All data transfer rate conversions within the SI family are purely multiplicative: you multiply the source value by a fixed conversion factor derived from the ratio of the two unit definitions. Imperial-to-metric conversions use the exact defined equivalences (e.g., 1 inch = 25.4 mm exactly) rather than approximations.

When precision matters, avoid rounding intermediate calculations. The displayed factors and results are rounded for readability, usually to ten significant digits; very large or small values use scientific notation. Use the original measurement for each conversion and round the final answer to match the accuracy of that measurement.

Keep the unit alongside each data transfer rate value when you copy or share it. Check that the source and target units match your task. If two units have similar names, read their definitions before selecting one.

For a second check, use the worked example and formula on the conversion page. Start from your original value rather than a rounded result from another calculator. If you need to report a specific number of decimal places, round once at the end.